Download Labeldownload
Aeris Seed-Applied Insecticide-Nematicide
CROP PROTECTION

Aeris Seed-Applied Insecticide-Nematicide

SeedGrowth
AERIS® Seed-applied Insecticide/Nematicide Seed Treatment for cottonseed represents advanced technology tailored for today's crop production. With Aeris, growers benefit from the broadest seed-applied spectrum of protection against early season insect and nematode pressures, thus establishing healthier, stronger seedlings and root systems. In university research trials and extension trials across the Cotton Belt, cotton treated with Aeris showed lower thrips damage and higher yield than cotton treated with base fungicide.
Approved In
AL, AR, AZ, FL, GA, KS, LA, MO, MS, NC, NM, OK, SC, TN, TX, VA
    FormulaRegistration Number
    liquid0000264-01057-AA-0000000
    Active IngredientFormulation
    Imidacloprid24 %
    Thiodicarb24 %
Labels / MSDS
Additional Downloads
Use and Mixin

Use and Mixing

The instructions for use and mixing described below are from the Environmental Protection Agency approved Federal Label. Always read and follow label instructions. Not all products are registered for use in every state. Please check with Bayer or your local Lead State Agency for product registration status. If you wish to find out if a product is registered in your state or for additional product information, send us an email or call 1-866-99-BAYER.
      PPE
      PERSONAL PROTECTIVE EQUIPMENT (PPE) Workers involved with treating the seed (e.g. connecting and disconnecting hoses and transfer pumps, mixing, equipment calibration, etc.) and others exposed to the concentrate, and cleaners/repairers of seed treatment equipment must wear a long-sleeve shirt and long pants, shoes plus socks, chemical resistant gloves made out of any waterproof material, and a dust/ mist filtering respirator (MSHA/NIOSH approval number prefix TC-21C) or a NIOSH approved respirator with any R, P, or HE filter. Baggers and bag sewers must wear a long-sleeve shirt and long pants, shoes plus socks, chemical resistant gloves made out of any waterproof material, and a dust/mist filtering respirator (MSHA/NIOSH approval number prefix TC- 21C) or a NIOSH approved respirator with any R, P, or HE filter.
      Tankmix Compatibility
      COMPATIBILITY It is essential that before using AERIS Seed-Applied Insecticide/Nematicide in any tank mixture the compatibility of the mixture be established. Add AERIS Seed-Applied Insecticide/Nematicide at the recommended label rate to a clean quart jar containing approximately one-half the amount of water intended for a final slurry application rate. Next, follow with all other tank mix components that will be used in the total slurry application. Add last the remaining balance of water. The total amount of volume is determined by the seed size and how much is necessary to ensure complete and uniform coverage and distribution on the seed, as well as the type of commercial seed treating application equipment that will be used. DO NOT USE MIXTURES THAT CURDLE, PRECIPITATE, OR GEL. FOR BEST RESULTS, TANK MIXTURES SHOULD BE USED IMMEDIATELY AFTER MIXING WITH ADEQUATE AGITATION. NOTE: Thiodicarb is hydrolytically sensitive to degradation of active ingredient by strong acids AND strong bases. DO NOT ADD AERIS SEED-APPLIED INSECTICIDE/NEMATICIDE TO WATER WITH pH VALUES BELOW 3.0 OR ABOVE 8.5. If necessary, water should be buffered within this range before adding AERIS Seed-Applied Insecticide/Nematicide. Degradation can cause reduced effectiveness, plant phytotoxicity and increased handling hazards.

Recommended Agronomy Resources

Featured
ARTICLE

Fighting Back Against Prolific Weed Resistance

Featured
ARTICLE

Bayer PLUS Rewards 10% Rewards Features

Featured
ARTICLE

Top 10 Tips For Corn Yields

Seed Brands & Traits
Crop Protection
Tools
Bayer
Disclaimer

Always read and follow pesticide label directions, insect resistance management requirements (where applicable), and grain marketing and all other stewardship practices.

Follow Us

©2024 Bayer Group. All rights reserved.